Reconfigure ECU (See SD sheet for details. Replaced one piece wire with two piece, ( (sensor and an extension) This code showing on diagnostics. Inactive diagnostic trouble code retrieval To display the trailer odometer mileage, apply ignition power and depress / release the brake pedal 7 times within 15 seconds. 1 xsetra Road Train Member 4,718 6,119 0 Sensor came out of axle end. Once the power is supplied, the switch is released and then pressed seven times. When you get to #7 this is important information to follow- “To enter the Reconfiguration Mode, the switch must be held in before the application of ignition power. The following table will tell you how to access those modes. For a code of 11-2, verify correct ABS configuration using blink codes or other diagnostic tool(s). PLC Select 2M: A C(x) code is common with 4S/2M configurations that have been changed to a 2S/2M or 2S/1M. They should not be displayed for more than two seconds if code remains permanently displayed, replace the ECU.

To get to the active and non-active codes, Bendix has developed a system that allows you access to the ECM by using different modes. X X Codes A(x) and C(x) are displayed when power is applied to the ABS ECU.

Bendix abs blink codes trailer